6
(numbered from 0-6). The channel knob allows you to select any of
nine frequency channels (numbered 0-8) within the selected group.
Replace bottom half of microphone case and turn clockwise until snug.
DO NOT OVER TIGHTEN.
(4) 2-Position switch
The bottom position is “Off” and the top position is “On”. Turning the
transmitter Off will cause the receiver to mute due to the tone squelch
circuitry at the receiver. This allows the mic to be handled with no noise.
(5) LED Indicator turns green when turned on. This LED will also turn
red to indicate that the battery level is low and the batteries must be
changed.
(6) The antenna attaches to the bottom of the microphone. It is screwed
on clockwise and should be snug.
The 51BT body-pack transmitter has 63 user selectable UHF frequen-
cies and is ideal for lavaliere and headset microphones. The optional
MP-1H instrument cable allows the 51BT to work with electric guitars
and basses.
(1) Open the battery compartment lid by sliding it down and raising it.
Then, insert one fresh alkaline 9-volt battery (2) into the compartment.
Make sure battery polarity is correct.Make sure battery polarity is
correct.
(3) Frequency select
The group knob allows you to select any of seven frequency groups
(numbered from 0-6). The channel knob allows you to select any of
nine frequency channels (numbered from 0-8) within the selected
group.
2
3
4
5
6
1
(3) Frequency select:
The group knob (left) allows you to select any of seven frequency
groups (numbered from 0-6). The channel knob (right) allows you to
select nine frequency channels (numbered 0-8) within the selected
group. Use the flat end of the provided tool to adjust these settings.
(4) Audio input Level Control:
Enables you to adjust the input level of the microphone or musical
instrument. Turn clockwise to increase, or counterclockwise to de-
crease the input level. Use the + end of the provided tool to adjust this
setting. The level control is factory-preset in the center position.
(5) Power and standby switches:
The power “On” and “Off” switch enables and disables all transmitter
functions while the audio switch “On” and “Standby” turn the audio off
and on. Switching the transmitter to “Standby” will cause the receiver to
mute using the tone squelch circuitry in the receiver. This allows the
microphone to be handled with no noise.
(6) LED Indicator:
Turns green when the transmitter is turned on. This LED will also turn
red to indicate that battery level is low and the battery must be
changed.
The 51XT plug-in XLR transmitter with 63 on-board user selectable
UHF frequencies is ideal for use with dynamic microphones with XLR
output.
(1) Open the battery compartment lid by sliding it down and raising it.
Then insert one fresh alkaline 9-volt battery (2) into the compartment.
page 6 page 7
(17 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern